Jump to content
Do Not Sell My Personal Information


How To Install Clutch Slave Cylinder


TokeTillDeath420
 Share

Recommended Posts

Ok i just put a 93 LSD tranny into my 91 Turbo... Its on, all good. I go to put the clutch slave cylinder on the front side of the transmission and i cant compress the pin to align it properly between the release fork and the 2 holes on top to mount it.... Im goin crazy over here, help would be nice! =-D thanks!

Link to comment
Share on other sites

try undoing the bleed screw, ive had it sometimes.

Link to comment
Share on other sites

Well it didnt work, so i just gave up and bought a new one for 30$... While bleeding the clutch (Which really wasnt as difficult as ive read online) I noticed that one of the lines on top was leaking... I tightened it down as tight as it could go, Un seated it and re-seated it... It still leaks through the threads as well as where the nut is seated on the tube... I called toyota and that part has been discontinued... Any ideas on how i could fix this? (Without going to a junkyard and getting one used) Anyone else have this problem before? Thanks.

Link to comment
Share on other sites

try to have a good look inside at the seat area of the cylinder and the end of the pipe, if either is scored then it will need replacing. if it is the pipe then you could get a replacement made for a few quid.

Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share




×
×
  • Create New...




Forums


News


Membership