Jump to content
Do Not Sell My Personal Information


  • Join Toyota Owners Club

    Join Europe's Largest Toyota Community! It's FREE!

     

     

How do I adjust handbrake imbalance? (Toyota MR2 mk3)


Jezzic
 Share

Recommended Posts

Hi there! I'm working on my friend's MR2 mk3 (W-reg/2000).

I've tightened up the handbrake cable for her as the car was previously rolling with the handbrake pulled up to the max when on any kind of slope. (Did the full whack - seats out, pump pedal with engine running to take up slack, etc. Was a long session as I also replaced the intermittently-not-working cigarette lighter socket so she could charge her phone on the go...) 

It is now much improved, but could be better. Pull it up with all your might and the car holds on a slope, but does give those creaking sounds that indicate that the brakes are barely holding the vehicle's weight.

I think one of the rear brakes is being applied fully while the other one is slightly slacker. The connecting plate that connects the two cables from the calipers to the single cable that runs to the handbrake "handle" is somewhat angled when under tension, so I assume that one brake is under full tension and the other isn't.

Is there any way to adjust the tension of the two cables that run to the left and right rear brake calipers?

Many thanks in advance,

Jezzic

Link to comment
Share on other sites

19 hours ago, Jezzic said:

Hi there! I'm working on my friend's MR2 mk3 (W-reg/2000).

I've tightened up the handbrake cable for her as the car was previously rolling with the handbrake pulled up to the max when on any kind of slope. (Did the full whack - seats out, pump pedal with engine running to take up slack, etc. Was a long session as I also replaced the intermittently-not-working cigarette lighter socket so she could charge her phone on the go...) 

It is now much improved, but could be better. Pull it up with all your might and the car holds on a slope, but does give those creaking sounds that indicate that the brakes are barely holding the vehicle's weight.

I think one of the rear brakes is being applied fully while the other one is slightly slacker. The connecting plate that connects the two cables from the calipers to the single cable that runs to the handbrake "handle" is somewhat angled when under tension, so I assume that one brake is under full tension and the other isn't.

Is there any way to adjust the tension of the two cables that run to the left and right rear brake calipers?

Many thanks in advance,

Jezzic

Not sure what you mean by "seats out".  I'm not familiar with your particular car but generally there isn't a way of adjusting cable tension independently - both sides should require approx the same amount of pressure to apply the brakes, thus the cable 'self-centres'.  In some cars (Avensis included) there are small handbrake shoes inside the brake discs which can be adjusted.  Is this the case with yours?  

Link to comment
Share on other sites

Latest Deals

Toyota Official Store for genuine Toyota parts & accessories

Disclaimer: As the club is an eBay Partner, The club may be compensated if you make a purchase via eBay links

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share






×
×
  • Create New...




Forums


News


Membership