Jump to content
Do Not Sell My Personal Information


  • Join Toyota Owners Club

    Join Europe's Largest Toyota Community! It's FREE!

     

Replacing 02 sensors frequently


steve mezzle
 Share

Recommended Posts

Hi Guys

Can anyone make any suggestions with this issue please on my 1998 Toyota avensis

I had my engine management light come on last week. Fault code 21 (oxygen sensor). Replaced with a second hand sensor. light went off  for 1 day and then management light come on again with same fault code.

The sensor that was replaced was the pre cat sensor (under the bonnet)

The car runs OK, no noticeable power loss , fuel efficiency seems the same.

replaced the spark plugs at the same time as the sensor as they were due anyway

New cat converter was fitted in July.

I tried to follow an online test i found to check the sensor heater and the heater appeared to be open circuit ( high ohm reading), havent tested this new one yet

Checked the voltage to the sensor was 12V and has ground

 

Ive done some internet searching and have found the following possible causes , but as i dont know enough about cars perhaps someone can narrow down some of these possible issues based on the info above.

Failed fuse, Exhaust leaks, running rich, damaged wiring back to ecu, faulty ecu, fuel injector, fuel pressure regulator, faulty thermostat, faulty mass air flow sensor, air leak exhaust manifold

 

Thanks in advance

 

Link to comment
Share on other sites

Latest Deals

Toyota Official Store for genuine Toyota parts & accessories

Disclaimer: As the club is an eBay Partner, The club may be compensated if you make a purchase via eBay links

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share






×
×
  • Create New...




Forums


News


Membership