Technical:Touch2 and Touch2 and/with Go

[preperationlaunch]

On 5/17/2022 at 9:06 PM, flash22 said:

i took that down as it was incorrect, you may like to update your profile

its 2016 isn't it ?? i will drop you a PM

Thanks again Bob.

Could I trouble you to take a look at this, as the wiring colours from Russia/China don't seem to line up with the wiring diagram.

From the diagram, I think yellow (1) should be chassis ground, pink (2) is the VSS, red (3) is switched live and black (4) is permanent live.

I essentially want to splice the switched live to power a relay to shut off permanent live to the nav unit when the car is off.

 

[flash22]

Go by pin number, not colour

V4 in the PDF is the socket view

as you look at your picture

4 3 2 1

8 7 6 5

 

pin 3 is Acc

pin 4 is perm 12v

You can verify that with a multimeter

 

switch live and ground for the coil. Permanent live on in/out to the the load side

 

it's more than likely android getting corrupted as it powers on/off and/or It's got an update it doesn't like, if the module runs off a sd/tf card back it up and change the card to something name brand