Jump to content
Do Not Sell My Personal Information


Spinning bolt rear bushing.


Kenito
 Share

Recommended Posts

Hi there! I've gotten a little mess now when I was gonna replace the rear bushing. The bolt is just spinning. The "cover" that was supposed to hold the nut in place was rusted so it loosened when I tried to remove it. It's very tight and narrow so it's hard to reach with any tool, I don't have a welder. I tried a "multitool" with a metall blade to cut it of, but halfway trough it the teeth look pretty worn down. Any experience with this?

235570281_3049460108632463_4415310533484030244_n.jpg

Link to comment
Share on other sites

If you cannot get a pair of vice grips on it. Then if you’re halfway through cutting it you might need to buy a couple of new blades to complete.

  • Like 1
Link to comment
Share on other sites

On 8/13/2021 at 12:39 PM, Bernard Foy said:

If you cannot get a pair of vice grips on it. Then if you’re halfway through cutting it you might need to buy a couple of new blades to complete.

thanks, the blades cost over 30 euroo a piece, I'm going with an anglegrinder now and just going through and will get it welded back, thanks!

Link to comment
Share on other sites

i dont where you are buying your blades in the uk we have Saxton blades that are cheap and good quality the Bosch blades are not that expensive

A wooden wedge would have done the job or even a pry bar

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share





×
×
  • Create New...




Forums


News


Membership