Hybridjunky

Registered Member
  • Content Count

    9
  • Joined

  • Last visited

Everything posted by Hybridjunky

  1. Absolutely; only anyone changing a bulb should make sure the unit is sealed properly afterwards to prevent any moisture ingress! 🙂
  2. The headlight suddenly died and upon inspection it turned out that the bulb was fine but the ballast was toast. Some 'smart alec' decided to fix the ballast at the lowest point of the unit resulting in any moisture going directly into the circuit. So I ended up buying a new ballast on ebay that set me back £23. I could not find any damage etc on the unit so it appears that the moisture probably got in from the loose dust cover at the back. I had to remove the grill and bracket below the grill from one side as well as pull away the bumper where it's clipped into the wing and managed to pull the unit out. The headlight unit itself is attached using 3 bolts; 2 on the top and one on the side that is accessible once the bumper has been pulled away. There is also a swivel point clipped into the bottom right side that just pulls out. Here are some photos.
  3. Brilliant thanks very much. I'll update once I've managed to do something about it. This is the only video I've found on youtube and it confirms that bumper needs to be removed!
  4. Thanks for the suggestion Neil. Yes by the looks of apart from the liner I may need to remove the grill as well as remove or at least lower the bumper unless the unit can be somehow lifted up and out.
  5. Hi folks The nearside headlight unit on my Estima has developed a fair amount of condensation recently so I am planning to remove it in order to try and find the source of the leak and essentially seal it if possible. I can see the 2 bolts at the top but not sure what else is holding the unit in place. Having looked at some photos of units for sale on Ebay it appears that there may only be one other bolt holding it which by the looks of it would be accessible from underneath the car from the inside of the wing. Would appreciate any info. Cheers
  6. Does this method work for the Toyota Estima? I do not have the tech stream software but just wondering if anyone has tried it on an Estima?! Thanks
  7. Thanks for that suggestion furtula. I've already done that and got the same answer "initial check". I would just like to know if other Estima hybrid owners get the same message at startup?! Cheers
  8. Ok so according to my Japanese friend it says initial check but if anyone knows otherwise please share. Cheers
  9. Just bought my first Estima Hybrid and noticed that just before Ready is displayed, it beeps and this message is displayed. I had the Lexus RX400 hybrid where it displayed a similar message and turned out that the petrol filling cap hadn't been tightened fully. I am hoping this is something trivial like that! Any input will be appreciated. Cheers