Jump to content
Do Not Sell My Personal Information


addz_slh

Registered Member
  • Posts

    38
  • Joined

  • Last visited

Profile Information

  • Toyota Model
    corolla

addz_slh's Achievements

Contributor

Contributor (5/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. After a lot of searching & running around i made up my mind. I went down the 10w 40 route semi synthetic. Hope that helps you guys in the future.
  2. Thanks a lot guys, 0W40 it is. Went to my local car parts store today and the guy recommended me 5w30. Surely that cant be right if i need 0W40.
  3. Will 0w40 be ok for my car? What is the difference between fully and part synthetic
  4. Hi guys. Time has come to service my Corolla G6 1.3 1999 model. What is the best Brand & Grade of oil to use? Alos part of fully synthetic? What oil filter should i use, should i go for any or branded? Want decent quality motor oil in the car as i do a lot of miles. Any information will be highly appreciated. Thanks in advance!
  5. Thanks. It is difficult to determine where the noise is comming from. It is defo not a heat sheild. Not an air leak as i can sit stationary rev upto 3rph & the noise will start.
  6. Hi guys. I have had a noise appear when the cars hot (sunny days). It's also do it before but not as much as now. I can't really describe the noise as its rather strange. Almost sounds like there's plastic touching somewhere. But its there & annoys me to pieces. I have taken 2 videos. It would be nice if anyone can help me on this. Thanks I have taken 2 pictures where i think the noise might be comming from, any idea what they are? Thanks in advance. Cars a Toyota Corolla G6 5dr 1.3 1999 model btw. http://uk.youtube.com/watch?v=VcWjE0V1ZwE http://uk.youtube.com/watch?v=7vow8C4a69E Any idea what they are? what would cause the noise?
  7. Hi. I have had my Toyota Corolla 1.3 G6 1999 model for around 6 months. I have always wanted a Starlet for the sake of it being a 1.3 Turbo - cheap to run - good performane. Now i have gauged interest in doing/getting done a 4EFTE conversion to my Corolla. Do the engine mounts line up? What is needed to get the conversion done? Is it something that can be undertaken by someone why is mechanical minded? Rough cost? Will i need to use starlet drive shafts? Will i need to replace the exsisting wiring loom? What else should i look-out for? Thanks in advance - look hearing from people who have done or yet attempted to do this Thanks!
  8. Thanks. So they are illegal? Apparently they dispense less heat than halogens though.
  9. Hi guys. I am very tempted to get my self this HID kit: http://cgi.ebay.co.uk/TOYOTA-COROLLA-ALL-8...Q2em118Q2el1247 Has anyone had any experiences with HID kits or yet even the above? Worth it or waste of money? Is there a difference or is it just all numbers? Thanks in advance!
  10. i test drove a 1.3 g6 a few years and it had drums on the back? rears are usually wind - in. make sure you reomove the sliders so you can clean and regrease them. Thought they might be wind-in / wind-back. My corolla has rear disc's. Many thanks mate.
  11. Does anyone know if the rear discs are wind-in? Its a Toyota Corolla G6 1.3 1999. Thanks in advance!
  12. Can anyonerecommend any alloys or web sites? I have a Toyota Corolla G6 Black 1999 model 5 door. Thanks in advance.
×
×
  • Create New...




Forums


News


Membership